Copy Trader for NinjaTrader 8: How to Copy Trades Across Prop Firm Accounts
Once you have several prop firm accounts, trading each one by hand is impossible: you enter late on some and forget the stop on others. A trade copier mirrors what you do on one account (the master) on all the others (the followers). Here is how it works and what to check before using one.
What a trade copier is
It is software that watches a master account and repeats its orders on other accounts: entries, stops, take profits, partial exits and moves to breakeven. You trade one account and the rest follow.
- Local copier: runs on your PC or VPS, next to NinjaTrader. It's the fastest, because orders don't leave for the internet and come back.
- Cloud copier: runs on another company's servers. It doesn't depend on your PC, but it adds another latency hop and gives a third party access to your accounts.
Before you copy: check your prop firm's rules
Every prop firm has its own rules about copying trades, and they change often. Always check the current version of yours:
- Your own accounts vs someone else's: almost all firms ban copying another person's trades or a signal group; copying between your own accounts is usually allowed, but not everywhere.
- Account limits: many firms cap how many funded accounts you can hold at once.
- Copying across firms: some don't allow the same trade on accounts at a different prop firm.
- Consistency and news rules: if one account has a rule another doesn't, the copy can break it.
The risks of copying
- One mistake multiplies: if you get it wrong on the master, you get it wrong everywhere.
- Different drawdowns: an account with a small cushion can be lost on the same trade another account survives easily.
- Two copiers at once: if you run a copier inside NinjaTrader and another one separately, orders get duplicated. Use only one.
- Slippage: on a fast candle, followers can fill a few ticks worse than the master.
How to set it up properly
- Pick one master and trade only on it.
- Size per account: use a multiplier (for example, ×2 contracts on followers) or the same size if all accounts have the same drawdown.
- Set each account's rules: daily loss, drawdown and profit target. Ideally each follower stops by itself when it hits its limit.
- Flat-master protection: if the master closes and a follower stays open (because of a rejection or a disconnect), the copier should close it.
- Test on Sim accounts before using it with real money or funded accounts.
The TQ Charts copy trader
TQ Charts includes a local copy trader in trading mode (Elite plan), connected to your own NinjaTrader:
- Mark one account as Master and the others as Follower, then turn it on with COPY.
- Entries, TP, SL, partials and breakeven are mirrored. All accounts share the same TP and SL.
- Contract multiplier, relative mode and flat-master protection.
- Per-account rules (daily loss, drawdown) and a daily profit target: when it's reached, that follower closes and leaves the copy until the next session, while the others keep going.
- Flatten all closes the whole group in one click, and the panel can be opened on another monitor.
The steps are in the copy trader tutorial. If you have another copier running in NinjaTrader, turn it off so orders aren't duplicated.